MADEIRA 9443 Avalon Stabilizer Fix Car Embroidery Soluble Water Soluble Adhesive

AVALON FIX

Wash - Away " stabilizer

24 cm x 1 m, Art. 9443
36 cm x 10 m, Art. 9434

Self-adhesive non-woven. water-soluble.
Ideal for all creative free-motion embroidery techniques and for the production of lace and borders. Instructions for use of AVALON FIX:

Embroidery of delicate fabrics: Cut AVALON FIX from the roll to the desired length and stretch it into the embroidery hoop with the protective film facing upwards. Carefully cut a diagonal cross into the middle of the protective film with the tip of the scissors. Caution – only engrave the protective film, not the guard. Remove the protective film slightly more than the pattern that is to be embroidered. Place the fabric on the free adhesive surface and press down firmly. After embroidery, carefully separate the fabric from the lining – the embroidery peels off by itself. Dissolve the remaining AVALON FIX with water.

Scarves with ribbons and wool: Cut AVALON FIX from the roll into the desired length of the scarf and place it on the
table or ironing board with the protective film upwards. Peel off the protective film, the adhesive surface is placed at the top. Place the tapes and wool on the adhesive surface as desired and press lightly. Cover with AVALON FILM (Art. 9440) or AVALON ULTRA (Art. 9441) in equal length and sew by securing the layers with a thread weave. The dots must be joined
so that everything does not detach after the dissolution of the film. Then wash the scarf with plenty of water.

Lace and border embroidery: Fix AVALON FIX in an embroidery hoop. Cut the protective film as described above and remove it to the desired extent. Then glue a lace or border in the middle of the surface
free adhesive. Embroider the lace/border with other shapes. After embroidery, cut off the surplus AVALON FIX and rinse off the remains.

Important: Always store AVALON FIX in the guard tightly closed. This will protect your stabilizer from dirt, moisture and heat.