Husqvarna Viking 920507096 Quilt Bias Binder Beader

This bias tape accessory is perfect for attaching bias tape even for a quilt. The Husqvarna Viking quilt binder has a large opening to accommodate the quilt layers and creates a final binding size of 1/2".

The Husqvarna Viking quilt binder comes with a dedicated cloth presser foot that also ensures feeding through the binder. and guarantees a perfect result.

The Double Fold 1/2" (12 mm) binder turns a lightweight woven strip of fabric into a binding and connects it to the edges of your project, all in one step.

To bias with the Quilt Binder Husqvarna Viking 1/2" (12 mm) quilt, cut a 1" (45 mm) wide strip of fabric.

• Attach the quilting foot with the guide.
  
• Set the machine to quilt stitch or hand quilt stitch.
  
• Place the attachment plate on the fixing plate of the machine. Align the pin on the back of the attachment plate with the top opening on the machine plate. Screw the supplied plate into place with a thumbscrew (supplied).
  
• Place the Quilt Binder on the needle plate and adjust the binder to align it. Attach the Quilt Binder in place with the two screws and washers.
  
• Measure the length of your project and add at least 6" (15 cm) of fabric.
  
• Cut enough 45 mm strips with the same number and join the strips. Cut the end of the strip in one spot.
  
• Slide the fabric strip into the binder with the wrong side facing up using tweezers.
  
• When the fabric crosses the end of the binder, hold the folded strip with your left hand and continue feeding it into the binder as shown while the fabric forms a double-fold ribbon.
  
• Lift the presser foot and pull the strip under the presser foot back 2.5" (5-6 cm) behind the needle.
  
• Slide the fabric up into the slot of the binder. Adjust the stitch position to the right or left to reach the desired needle position.

How to sew a corner with the Quilt Binder:

Sew on the edge of the quilt, tie and then pull the quilt out of the Quilt Binder.
Keep the quilt close to the Quilt Binder when folding the corners. Press the folded fabric with your finger.

Create a square corner:

• Fold and pinch the oblique top corner. Repeat in the same way on the back of the quilt.
• To continue sewing the binding, pull the strip of fabric through the binder and at the same time place the quilt in the presser foot and back into the binder.
• To ensure that the crease is correct on both sides and back, pull the quilt back and forth a few more times.
• Lower the needle to hold the binding in place, and remove the needles. Pull out long tails of thread behind the presser foot before you start sewing.
• Topstitch and sew the bias tape in place. Repeat on the other corner