Husqvarna Viking 413286545 Transparent foot for invisible hinges

Invisible zippers (sometimes called hidden zippers) are often used in the center back of clothing, on the sides or back of pants and skirts, and in some home decoration projects. As the name implies, the zipper is hidden in a seam and becomes virtually invisible. It is often thought that the application of hinges is very difficult to perform; It's actually very easy, especially if you use the transparent invisible zipper foot HUSQVARNA VIKING.

• Mark the length of the zipper opening in the seam allowance and on the zipper.
• The excess length should be found at the bottom of the zipper.
• Engages the transparent foot for invisible zipper
• Select the straight stitch in the center needle position. Length 2.5-3.0.
• Place the right side of the zipper on the right side of the seam, right side on the right side. Place the spiral on the seam line, starting about 2 cm below the cut end of the fabric.
• Carefully press the teeth of the hinge slightly to the right and lower the presser foot, so that the spiral rests in the groove to the right of the needle.
• Stop at the mark on the zipper and seam allowance and cut the thread.8. Place the second zipper tape on the left side of the opening, right sides over.
• Make sure both spirals are horizontal.
• Pin the zipper into place. Open the zipper.
• Lower the presser foot with the left groove on the hinge teeth. Sew in the same way as in the first guide.
• Close the zipper. Place the fabric with the zipper right sides up. Pin the rest of the fabric under the zipper right sides up.
• Attach the E foot for zippers to the left of the needle. Adjust the needle position as needed.
• Sew from the low end and until the zipper overlaps the backstitch seam.
• Iron the zipper open.

Note: Buy an invisible zipper that is at least 3 cm longer than the zipper opening.